How to use: 1. After the product is powered on, the indicator and LED will light for 1 second. The buzzer emits a long sound. LED- shows real-time temperature and goes into standby status. 2. Boil/stop button: When you touch this button, the buzzer sounds "di" and the kettle starts to operate. Touch the button again - the kettle will stop working. 3. C button: Touch this button and the led temperature display will switch between centigrade. 4. The LED will always show the real-time temperature of the water inside. 5. Bell: One sound with each press. 6. Fault display: Sensor open circuit: E1- sensor short circuit: E2- overtemperature: E3. Kettle - stops working immediately when the error code is displayed. 7. Rated voltage is 220v- rated power is 1500w. Cleaning and maintenance: 1. Before cleaning, unplug the product and wait for the surface of the kettle to cool down before cleaning. 2.Never use steel wool, abrasive cleaners or aggressive liquids such as gasoline or acetone to clean the product. 3.Do not immerse the kettle or its base in water or any other liquid. 4.Wipe the exterior of the kettle with a wrung-out towel and a non-hazardous cleaner. 5.When the product is not used for a long time - please clean it - put it in the box and keep it in a ventilated and dry place to avoid moisture and affect its use. Descaling tips: 1.Regular descaling will extend the life of the kettle. 2.For normal use (5 times a day) - descaling is recommended as follows: If the water quality is soft (up to 18d h) - descaling should be done every 3 months If the water quality is hard (above 18d h) - once a month A. Fill the kettle with water to 3/4 of the maximum level and boil the water. B. After stopping the heat, add white vinegar (8% acetic acid) to the maximum water level. C. Leave the solvent in the electric kettle overnight. D. Drain the solvent and rinse the inside of the kettle thoroughly with water. E. Fill the kettle with water and boil it.
EN − EUR
